I just got the nailer and haven't used it yet - but I wanted to give people who have this nailer or who are reading the other reviews some guidance for putting on the leather cover. It seems to be baffling folks - but since my previous palm nailer from Harbor Freight had a similar cover I could figure it out.
Put the silver ring around the nose - then loosely wrap the leather cover around the nailer so that the large hand loop is on the back side. Pass each of the 3 larger straps (they have the 'male' side of the snap) from the inside (nailer side) of the ring OUT through the ring and then push them over the edge of the ring to reach each of the female sides of the snaps. They should be at 12 o'clock, 3 o'clock and 9 o'clock. The last one is tough to get it to reach, but it will get there if you pull. Try wetting the leather a little to get it to stretch.
The smaller snaps encircle the male compressor coupler. Again, the last one takes a little work but it will go.
My impression of the nailer is that it seems solid - but it is heavy feeling. I was thinking of getting the PN50 because it weighs just a pound and I only use this for nailing TECO nails (joist hanger nails). I'll see how it goes on the job...
(53 customers reviews)
Customers Rating=4.5 / 5.0
More Detail For Bostitch PN100K Impact Nailer Kit
- Palm nailer kit; ergonomic design; magnetic nose;
- Ideal for driving common bulk nails-inch confined areas or for nailing off metal connectors and joist hangars
- Hardened steel nose for durability; leather glove
- Includes nailer, standard nose, finish nail nose, large bore nose, leather glove, nose wrench, hex wrench, lubricant, spare O-rings
- 5.25 by 3.5 by 4.13-inches; 2.9-pounds; 7-year limited warranty
ไม่มีความคิดเห็น:
แสดงความคิดเห็น