This beast looks scary but works pretty well. For PVC the cut offs need to be at least 3/4" thick or the scrap shatters and sends shrapnel flying. I have used it for 2" PVC, 3/4" & 1/2" PEX, and 1" plastic conduit. Worked well in all materials. The safety switch is hard to hold at the same time you are pulling the trigger. At least I haven't found a good way yet. It has plenty of power to cut 2" and is very quick. Chop saw is faster and more square but with this you have no dust,it is pretty much silent, and very portable (cut in place). The cuts are more square than a Sawzall with no ragged edge to deburr. It is faster than a ratchet manual shear and won't wear out your grip if you have to do a bunch of cuts. Plus if you have the batteries & charger the bare tool cost is reasonable. Wish they would reposition the safety switch.
(1 customers reviews)
Customers Rating=4.0 / 5.0
More Detail For Bare Tool Milwaukee 2470 20 M12 12 Volt Cordless PVC Shear Tool Only No Battery
- Powerful Mechanism - Cuts up to 2" schedule 40 PVC in 3 seconds. Ultra Sharp Blade with Pierce Point - No burrs or shavings to remove
- Offset Blade - Cuts PVC / PEX in-wall, in-ground, or close to wall Quick Return Blade - Increased productivity during repetitive cuts. All Metal Planetary Drive - Delivers over 200 cuts per charge
- Stainless Steel Blade and Aluminum Jaw - Impact, water and rust resistant
- Variable Speed Trigger - Controlled cut in warm or cold weather
- On Board Fuel Gauge - Displays remaining run-time
ไม่มีความคิดเห็น:
แสดงความคิดเห็น